Spindle Installation Guidelines

 I. Preparation Before Installation

Drawing Preparation

Prior to installation, ensure that the spindle assembly drawings are prepared or that the spindle shaft system structure is clearly understood. Confirm all necessary components and the specific bearing installation method applicable to the spindle.

Spindle Components Preparation

Before mounting the bearings, thoroughly clean the shaft, housing, and all associated components. Surfaces must be free from burrs, protrusions, or any contaminants. Verify the dimensions of the shaft and housing bore to confirm they meet the assembly specifications.

For spindle assemblies that incorporate spacers between bearings, check both the parallelism and height variation of the inner and outer spacers. The parallelism should not exceed 0.003 mm, and height difference must be within 0.002 mm.

Bearing Preparation

Open Bearings: These bearings must be cleaned before installation. Hold the inner ring while keeping the outer ring surface facing upward, and rotate the outer ring during cleaning. Alternatively, place the bearing at an angle in a container with the outer ring facing downward and rotate the inner ring. Suitable cleaning solvents include clean No. 120 aviation gasoline, kerosene, or anhydrous alcohol. Once dried, apply the appropriate type and quantity of grease as specified in the bearing product catalog.

Sealed Bearings: Do not clean sealed bearings. Simply wipe the outer surface clean before use.

II. Bearing Installation

Installation of Bearings

After confirming the correct orientation of the bearings, use an induction heater to warm the bearings before installation. The recommended heating temperature is between 70°C and 80°C. Install the bearings in accordance with the spindle shaft structure and in the correct sequence.

Locknut Tightening

Only tighten the locknut after the shaft has completely cooled down. Use a torque wrench to apply the manufacturer-recommended tightening torque.

Cover Installation

When installing the bearing outer ring cover, tighten the bolts in a crisscross pattern over 2–3 stages. Prior to installation, ensure the gap between the end face of the cover and the bearing housing surface is maintained within a range of 0.02–0.04 mm.

III. Inspection and Run-In

Precision Inspection

Before proceeding to full operation, manually rotate the spindle to check for smooth motion. Use a dial indicator to measure the shaft end accuracy, ensuring it aligns with the required installation precision standards.

Spindle Run-In Procedure

Prior to mounting the spindle on the machine, conduct a controlled run-in. Start by operating the spindle at 10%–15% of its maximum speed, then gradually increase the speed in 10%–15% increments. At each stage, maintain operation for approximately 30 minutes to ensure proper bedding of components.

Following these spindle installation guidelines ensures the optimal performance and longevity of your spindle system, especially in high-speed or precision machining applications.

About us

Luoyang Bearing Research Institute Co.,Ltd. was established in 1958. It is the only state-level comprehensive research institute in China's bearing industry.

ZYS focuses on developing high-performance bearing products for key units of national economic construction. We perform batch production of various high-rank bearing products and components with inner diameter of 0.6mm to outer diameter of 6.8m. We are mainly engaged in the research, development, production and sales of precision bearing, special bearing, high-speed machine tool spindle, bearing special equipment, bearing testing instruments, bearing testing machine and bearing special materials, which are widely used in the fields of, machine tools, wind power generation, mine metallurgy, petrochemical, medical equipment, automobiles and rail transit, construction machinery, intelligent manufacturing services, etc.

We have total assets of 2.06 billion RMB, own one research and development center, three industrial bases and cover an area of more than 47 hectares. We have advanced bearing manufacturing equipments and world first-class testing equipments and have solid strength in manufacturing, measuring and testing of bearing and related components with high precision and high reliability. We have more than 380 technical staff of bearing related disciplines, thus we maintain a leading position in the aspects of bearing design, basic theoretical research, lubrication technology, metallic and non-metallic materials, testing and industry standards.

Website: www.zys-bearing.com

Email: sales@zys.com.cn